![]() ![]() Pretty much as soon as I said 73, the band closed, and I didnt. 2) Make sure the DAX button is clicked in the P/CW tab on the right. This article explains the relationship between anxiety and sensory overload symptoms. 4) Make sure the TX button is RED 5) Your setup should look like the graphic below DAX Setup 1) Click the DAX tab in the slice and set the channel to 1. Sensory overload, such as feeling like your nervous system is being bombarded and overwhelmed by visual, auditory, taste, touch, and smell stimuli, is a common symptom of anxiety disorder. 3) Set the mode to DIGU, Filter to 3K or 5K. only a qualified service technician can replace and repair those. I was at work this afternoon, OK not so good being the weekend, however as I have the place to myself and as long as the work gets done, then the rest of the time is my own, and what better way than to spend my lunch-hour doing some radio from the mobile. 1) Open SmartSDR and connect to your radio. Choose PTT via serial Com port and put in the lower of the two Com port numbers created for the PTT pair in SmartSDR. The only issue (so far, lol) is that when I use DM780 for SSTV, I am having trouble with the horizontal positioning of some images from some stations. if your competent in checking under the cover, you will see that the top silver area on top of the capacitors are starting to bulge, they should be flat on top, if they appear to be splitting open, means they need replacing. Start DM780 and in DM780 program options Click on PTT. Means: the safety overload protection breaker is clicking on inside making that “clint" soundġ) one of your capacitors on one of the channels inside the unit is blownĢ) you have impedance on speakers that is larger than the unit can drive check Max ohms is not greater that the units Output….this can also happen in reverse, ie: you are using speakers too low to be connected to the unit, as soon as you up the volume you will hear the capacitor shut off and make a “Clint” sound inside the unit, this is the protection breaker and will display overload on the LED panel.ģ) you have Wires out of phase (meaning positive is in a negative somewhere on the speaker or rear of the unit)ġ) Disconnect each speaker and turn on until the problem ceases, this will determine which speaker is had it, or out of phase.Ģ) if you are powering speakers A and B External at the same time, turn one off, as the speakers do not match to be run at the same time with A and B runningģ) lower volume as well as turn between left and right balance to check those capacitors aren’t fried inside the unitĤ) if you disconnect all speakers and inputs and turning on the unit still activates the protection breaker and Overload is still showing….means your Amp is had it, and one of the main pots (that look like Dcell Batteries on the main circuit board ) are toast.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |